QuelStop Fire Batt
The QuelStop Fire Batt is a coated mineral wool board used to reinstate the fire rating of wall and floor constructions where they have been penetrated by services.
Application
- Suitable for use in flexible walls, rigid walls and floors
- Suitable for use around cables, cable bunches, cable trays, cable ladders and non-combustible pipes
- Can be used as a blank seal as a head of wall detail
- Can be installed into both lined and unlined apertures in partition walls
- Can be installed as a single or double batt seal
- Can be pattress fitted / face fixed to walls
- Tested with plasterboard ceilings and steel composite profile decks
Testing
- Fire resistance testing to BS EN 1366-3:2009
- Up to 2 hour fire rating
- Classified to EN 13501-2: 2007 A1:2009
- Acoustic tested to EN 10140 to 60 dB
- CE Marked
QuelStop Intumescent Acoustic Acrylic Sealant
QuelStop Intumescent Acoustic Acrylic Sealant is a water-based intumescent acrylic used to provide a fire rated linear joint or gap seal and to maintain the fire rating of walls and floors where they have been penetrated by services as part of the QuelStop Fire Batt system or direct to the substrate.
Application
- Used as part of the QuelStop Fire Batt system
- Suitable for use around cables, cable bunches, cable trays, cable ladders and non-combustible pipes
- Suitable for use in flexible walls, rigid walls and floors
- Suitable for linear joints up to 50mm wide in concrete to concrete/steel/softwood
- Suitable for linear joints up to 20mm wide with gypsum board/steel headtrack
- Suitable for low movement joints and remains flexible - maximum movement capability is <7.5%
- Suitable for use around wooden fire door frames
- Up to 4 hour fire rating (EI240)
- CE marked
Testing
- Fire resistance testing to BS EN 1366-3:2009
- Fire resistance testing to BS EN 1366-4:2006
- Classified to EN 13501-2: 2007 A1: 2009
- ETA: 17/0788 & ETA: 17/0789
- Acoustic tested to EN 10140 to 48dB
- Air Permeability testing to EN 1026 to 600Pa - 100Pa 0.0/0.0m3/h/m2
- VOC Tested ASTM D2369-10, LEED 2009-EQ041 SCAQMD
Quelstop Ablative Coating
The QuelStop Ablative Coating is used to reinstate or repair the fire resistance performance of the ablative coating of the QuelStop Fire Batt where damage or cracks may have occurred during installation.
It is also required in some applications to coat back individual services as part of a tested system where they penetrate the compartment line.
Features
- Fire tested to BS EN1366-3-2009 as part of the Quelstop system
- Provides fire resistance to some service penetrations
- Simple to install, by brush application
- Contributes to providing a smoke seal
- Supplied in 5kg resealable tubs
Please log in to send us a question regarding this product.
