With its panels separated with horizontal grooves and deep construction, manufactured using American white oak, the Palermo Essential Fire Door is fully certified for 30 minutes fire protection (FD30), when installed with fire rated linings and hardware.
An engineered construction and a solid core offer better sound insulation and heat retention than budget imitators.
Supplied unfinished, ready for you to apply the stain or colour of your choice at home.
Specification
- FD30 - 30 minute fire rating
- 1981 (H) x 762 (W) x 44mm (T)
- Weight: 36kg Approx
- Unfinished oak
- Core material - Particleboard
- 3 x 4" Butt hinges required
Features
- Deep chamfered u-grooves
- 7 Panel design
- Reversible door handing
- Lipped on all four sides (11mm)
- 10 year guarantee from manufacturer
Handling & storage
Doors should always be stored flat, ideally in the same room where they are to be installed.
Protect the door from damp and dirt by leaving it in its protective packaging until ready for finishing and fitting. Doors should not be fitted where extremes of temperature or humidity may occur, e.g. in a newly plastered room or near a sauna. In new build situations the doors should only be fitted when the property is ready for final decoration.
Installation
When trimming a fire door to fit, 2mm can be removed from each edge of the door to a maximum reduction of 4mm in both the height and width. Any reduction must be removed evenly from each edge of the door, e.g. to trim your door by 4mm in width, remove 2mm off each side.
A groove must be routed around the top and two sides of the door or frame for the installation of intumescent strips.
Three hinges should be used to hang all doors, to prevent warping or bowing.
Latches and locks should not be fitted adjacent to door mid-rails where the joint may be compromised.
All hardware screw holes should be pre-drilled to prevent splitting of the timber.
Finishing
Doors will require a light sanding prior to finishing using a fine grade sandpaper (grit number 240 or 320).
All timber surfaces should be fully finished. Failure to treat all the timber surfaces may lead to excessive changes in moisture content which will cause the timber to shrink or swell, possibly causing splits and distortion. Please refer to the finish manufacturer’s application instructions for further details.
Use a good quality paint, stain or varnish suitable for veneered doors. Apply first coat of finish immediately after unpacking doors from protective packaging. Apply coats equally to all faces and edges including the top and bottom of the door prior to final fitting. Use the same number of coats for lock, latch and hinge cut-outs. DO NOT Use oils, wax, dyes or preservative treatments. Use thinned/mixed paints or stains. Mix incompatible products, e.g. paint on one door face and stain on the opposite face.
Please log in to send us a question regarding this product.