Trend Two Part Skeleton Hinge Jig

The two part contractor hinge jig is a portable fully adjustable block template set designed for recessing hinges in wooden doors and frames using a plunge router.

Features

• Easy to use with minimal setting-up time, completing the job both accurately & quickly
• Fully adjustable apertures for fire door requirements and renovation work
• Can be used on both internal and external doors, rebated frames and on maximum 25mm thick fixed stops
• Ideal for fitting a new door in an old frame
• No need for marking out in the conventional way
• Clean & accurate recesses are achieved every time
• Suitable for timber based doors & square butt hinges
• Use with a light duty plunge router with 1/4 inch collet
• Long reach router cutter required, 12mm diameter with 70mm overall length
• Adjustable edge guides with preset for hinge of 20mm, 25mm and 30mm
• Unibase may be needed

Specification

Hinge sizes:

• Length min: 2 5/8" (67 mm)
• Length max: 5" (127 mm)
• Width min: 1/2" (12.7 mm)
• Width max. in 35mm fixed rebate: 23mm
• Width max. in 44mm fixed rebate: 32mm

Door sizes possible:

• Height min.6' 5" (1956 mm)
• Height max.2100 mm* (6' 10"*)
• Thickness min.5/8" (16 mm)
• Thickness max.2" (51 mm)
• Edge stops thickness6 mm
• Weight2.9 kg
• Jig overall length1956 mm
• Plate thickness3 mm
• Fixed stop max. thickness25 mm**

* Please note for doors over 2040mm the bottom hinge will be higher than 9" up.

** Max. hinge leaf width 23mm (35mm doors)